Connecting my Full Node to Sui Explorer

Quick question for y’all.

Last night I set up a new Full Node. I opted to install the prerequisites and built from source rather than using docker.

Everything went smoothly, my node has fully synced without issue. I can verify this using the Scale3 node checker:

However, when I open the Sui Explorer, switch to custom RPC, and attempt to connect to my node, I only see errors:

I assume the solution is something simple like port forwarding, but before I start breaking stuff, I figured I’d post here in case anyone has advice.


Oh I have the same error. Have you found a solution @mosaicRegressor ?

1 Like

No, I haven’t had a chance to spend more time on it. I’ll try to dig into it a bit tomorrow evening.

1 Like